MySQL Forums
Forum List  »  MySQL Workbench

Re: Adding "ALTER TABLE" command to FWD Engineer
Posted by: Mike Lischke
Date: September 10, 2009 02:16AM

Hey Dan,

if it is only about the auto increment value then you can use the table editor in WB to set the initial value (see options page). This will also work properly with synchronization, since changed properties outside of WB will always make WB consider it as something to re-sync.

Mike

Mike Lischke, MySQL Developer Tools
Oracle Corporation

MySQL Workbench on Github: https://github.com/mysql/mysql-workbench
On Twitter: https://twitter.com/MySQLWorkbench
On Slack: mysqlcommunity.slack.com (#workbench)
Report bugs to http://bugs.mysql.com
MySQL documentation can be found here: http://dev.mysql.com/doc/refman/8.0/en/

Options: ReplyQuote


Subject
Views
Written By
Posted
2774
September 09, 2009 11:12PM
Re: Adding "ALTER TABLE" command to FWD Engineer
1787
September 10, 2009 02:16AM


Sorry, you can't reply to this topic. It has been closed.

Content reproduced on this site is the property of the respective copyright holders. It is not reviewed in advance by Oracle and does not necessarily represent the opinion of Oracle or any other party.