Is there a way to "capture" a specific error code?
Is it possible to capture an error code? I am trying to set up an automated data migration process. Part of the process is to write to an audit table. I would like to indicate whether or not the job succeeded. If not, I would like to write the exact error message that was thrown.
Subject
Written By
Posted
Is there a way to "capture" a specific error code?
November 17, 2015 07:08PM
December 09, 2015 05:42AM
Sorry, you can't reply to this topic. It has been closed.
Content reproduced on this site is the property of the respective copyright holders.
It is not reviewed in advance by Oracle and does not necessarily represent the opinion
of Oracle or any other party.