MySQL Forums
Forum List  »  Connector/Arduino

Re: Announcing Connector/Arduino 1.0.1b
Posted by: Noam Parness
Date: February 05, 2014 09:05PM

Well, so far it looks good. I upgraded to the v1.0.1b library, then recompiled and re-downloaded the sketch to the Arduino.
I tested by unplugging the network cable right after it connected (but before it finished sending the query). It timed out, exited out, and completed the rest of the loop. It went on to run through the loops properly, attempting to connect each time (per my code). When I reconnected the cable, it picked up right where it had left off, and resumed inserting the data into the database for me.
Very well done.
Thanks for your hard work.

Edited 1 time(s). Last edit at 02/05/2014 09:07PM by Noam Parness.

Options: ReplyQuote

Written By
February 04, 2014 03:44PM
Re: Announcing Connector/Arduino 1.0.1b
February 05, 2014 09:05PM

Sorry, you can't reply to this topic. It has been closed.

Content reproduced on this site is the property of the respective copyright holders. It is not reviewed in advance by Oracle and does not necessarily represent the opinion of Oracle or any other party.